Parts designed by jmacz on the 68kMLA forums (68kmla.org).
Distributed by MacDat with permission.

Included Files:

One Piece Support for Inserts - Full part with holes large enough to fit brass inserts.
Made for the following brass inserts: M2.5, 6mm deep, 4mm outside diameter.
Use M2.5 screws with 8mm length.

Two Piece Support Left/Right for Inserts - Same as above (same screws and insert size), but split into two smaller pieces.
Use these files if you only wish to replace one side, or if you don't have a large enough printer for the full part.

Two Piece Support Left/Right for Screws - Same as above, but made to reuse the original hinge mount screws. Less work,
but may be weaker than the other parts.